One-Touch Tuning Stop (Obj. 2D52H)]; [One-Touch Tuning Stop (Obj. 2D52H: 00H)]; One-Touch Tuning Clear (Obj. 2D53H)]; [One-Touch Tuning Clear (Obj. 2D53H: 00H)] - Mitsubishi Electric MR-J5-G-N1 User Manual

9.65

[One-touch tuning Stop (Obj. 2D52h)]

[One-touch tuning Stop (Obj. 2D52h: 00h)]

Data Type Access
U16 RW
Supported firmware version

ECT

A5
Description
Set a one-touch tuning stop command. To check whether the setting is reflected, read [One-touch tuning mode (Obj. 2D50h)].
• 1EA5h: Stops one-touch tuning.
• Other than 1EA5h: Triggers a parameter out of range error.
When the object is read, whether one-touch tuning can be stopped is returned.
Bit Description
0 0: One-touch tuning can be stopped with the command. (One-touch tuning in progress)
1: One-touch tuning cannot be stopped with the command. (One-touch tuning not in progress)
1 to 31 
9.66

[One-touch tuning Clear (Obj. 2D53h)]

[One-touch tuning Clear (Obj. 2D53h: 00h)]

Data Type Access
U16 RW
Supported firmware version

ECT

A5
Description
The servo parameter that was changed in one-touch tuning is returned to the value before the change. To check whether the
setting is reflected, read [One-touch tuning mode (Obj. 2D50h)].
• 0000h: Restores to factory setting
• 0001h: Restores to the value from before one-touch tuning
When the object is read, whether the servo parameter that changed in one-touch tuning can be restored to the value before
the change is returned.
Bit Description
0 0: Cannot be restored to factory setting with the command. (One-touch tuning in progress)
1: Can be restored to factory setting with the command. (One-touch tuning not in progress)
1 0: Cannot be restored to the value before one-touch tuning with the command. (One-touch tuning has not been performed for the axis,
one-touch tuning is in progress for the axis, or an incorrect axis was selected.)
1: Can be restored to the value before one-touch tuning with the command. (One-touch tuning executed)
2 to 31 
9 Manufacturer Specific Control Object
138
9.65 [One-touch tuning Stop (Obj. 2D52h)]
Mapping Default
Impossible 0000h
 
 
Mapping Default
Impossible 0000h
 
 
Range Units

0000h, 1EA5h
 
 
Range Units

0000h to 0001h
 
 
Save Parameter

Impossible
 
 
Save Parameter

Impossible
 
 