One-Touch Tuning Error Code (Obj. 2D54H)]; [One-Touch Tuning Error Code (Obj. 2D54H: 00H)]; Software Reset (Obj. 2D5Fh)]; [Software Reset (Obj. 2D5Fh: 00H)] - Mitsubishi Electric MR-J5-G-N1 User Manual

9.67

[One-touch tuning Error Code (Obj. 2D54h)]

[One-touch tuning Error Code (Obj. 2D54h: 00h)]

Data Type Access
U16 RO
Supported firmware version

ECT
A5 
Description
An error code of the one-touch tuning is returned.
Refer to "One-touch tuning error" in the following manual.
MR-J5 User's Manual (Adjustment)
0000h: Properly completed
C000h: Tuning canceled
C_01h: Overshoot exceeded
C_02h: Servo-off during tuning
C_03h: Control mode error
C_04h: Time-out
C_05h: Load inertia moment ratio misestimated
C_06h: Servo amplifier built-in command start error
C_07h: Servo amplifier built-in command generation error
C_08h: Stop signal
C_09h: Parameter
C_0Ah: Alarm
C00Fh: One-touch tuning disabled
9.68

[Software reset (Obj. 2D5Fh)]

[Software reset (Obj. 2D5Fh: 00h)]

Data Type Access
U16 RW
Supported firmware version
ECT 

C4
Description
Writing "1EA5h" performs the software reset. Writing a value other than "1EA5h" triggers a parameter out of range error.
When the object is read, "0000h" is returned.
Mapping Default

Impossible
 
 
Mapping Default
Impossible 0000h
 
 
Range Units

Refer to the
following.
 
 
Range Units

0000h to FFFFh
 
 
9 Manufacturer Specific Control Object
9.67 [One-touch tuning Error Code (Obj. 2D54h)]
Save Parameter

Impossible
 
 
Save Parameter

Impossible
 
 
139
9