Point Table 002 (Obj. 2802H)] - Point Table 255 (Obj. 28Ffh)]; Target Point Table (Obj. 2D60H)]; [Target Point Table (Obj. 2D60H: 00H)]; Point Demand Value (Obj. 2D68H)] - Mitsubishi Electric MR-J5-G-N1 User Manual

16.2
[Point table 002 (Obj. 2802h)] - Point table 255 (Obj.
28FFh)]
Positioning data of the point table can be obtained and set.
The contents of each Sub Index are the same as [Point table 001].
16.3

[Target point table (Obj. 2D60h)]

[Target point table (Obj. 2D60h: 00h)]

Data Type Access
I16 RW
Supported firmware version

ECT

B8
Description
The values of the specified point table number can be obtained and set.
Operation mode
Point table mode (pt)
16.4

[Point demand value (Obj. 2D68h)]

[Point demand value (Obj. 2D68h: 00h)]

Data Type Access
I16 RO
Supported firmware version
ECT 

B8
Description
The point table number which is currently being commanded is returned.
When the servo motor is stopped, the setting value of [Target point table] is returned.
Operation mode
Point table mode (pt)
16 Point table Mode Objects
188

16.2 [Point table 002 (Obj. 2802h)] - Point table 255 (Obj. 28FFh)]

Mapping Default
RxPDO 0
 
 
Mapping Default
TxPDO 
 
 
Range Units

-1 to 255
 
 
Description
0: Does not operate.
1 to 255: Execute the specified point table.
-1: Positioning to the home
Range Units
-1 to 255 
 
 
Description
0: Not specified
1 to 255: The point table number which is currently being commanded
-1: Positioning to the home
Save Parameter

Impossible
 
 
Save Parameter
Impossible 
 
 