Step 13. Attach Header To Windrower - MacDon A30-S Assembly Instructions Manual

H
G
BOTH SIDES
g. Set forming shield side deflectors to desired
width by repositioning adjuster bars (F).
same hole location on both sides.
• Position deflectors at the narrowest
setting for a narrow windrow (silage for
example).
Position deflectors at the widest position
•
for a wide window.
Refer to the Operator's Manual or Quick
Card for additional
adjusting the forming shield.
h. Adjust fluffer shield (G) to middle position.
Loosen handles (H) if required.
STEP 13. ATTACH HEADER TO
WINDROWER
B
a. Remove pins (A) from left and right header
boots.
Form 169078
UNLOADING AND ASSEMBLY
F
NOTE
information
A
Use
To prevent damage to the lift system when
lowering header lift linkages without a
header
windrower, ensure that float engagement
pin is installed in storage location (C), and
not installed at hole location (D).
on
Check to be sure all bystanders have cleared
the area.
HEADER
TILT DOWN
b. Start the engine, and activate HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
18
C
D
IMPORTANT
or weight box attached
CAUTION
HEADER UP
HEADER TILT UP
HEADER DOWN
(continued next page)
to
Revision C