Step 10. Attach Header; Header Attachment - D Series - MacDon M105 Assembly Instructions Manual

STEP 10. ATTACH HEADER

A. HEADER ATTACHMENT - D SERIES
IMPORTANT
A light header float kit may need to be
installed, depending on the header
size and configuration.
IMPORTANT
To prevent damage to the lift system
when lowering header lift linkages
without a header or weight box
attached to windrower, ensure that
float engagement pin is installed in
storage location (A), and not installed
at hole location (B).
D
a. If not installed, attach draper header boots
(supplied with header) to windrower lift linkage
as follows:
1. Remove hairpin, and remove pin (C) from
boot (D).
Form 169558
UNLOADING AND ASSEMBLY
A
B
C
D
2. Locate boot (D) on lift linkage (E), and
re-install pin (C). Pin may be installed from
either side of boot.
3. Secure pin (C) with hairpin.
4. Repeat for opposite side.
F
b. Remove hairpin on pins (F), and remove pins
from header legs.
CAUTION
Check to be sure all bystanders have
cleared the area.
21
E
C
(continued next page)
Revision A