Table of Contents
Advertisement
STEP 9. INSTALL AM/FM RADIO
Provision has been made for installation of
AM/FM radio. The mounting is designed to fit a
DIN E style radio with a depth X=161 mm and
having a 5 mm threaded stud centered on the
rear for support. Provision has been made for
adjustments should the radio fall outside these
parameters.
a. Ensure the ignition is turned to the OFF position.
b. Remove radio panel by removing four screws
(A).
E
c. Remove screw and nut (C) to remove support
(D) from panel.
lockwasher.
d. Remove the cut-out by cutting the tabs (B) in the
panel. Remove sharp edges on panel.
Form # 169390
UNLOADING AND ASSEMBLY
X
A
D
C
Retain metric nut (E) and
B
F
e. Locate receptacle (F) (supplied with radio) in
opening and secure by bending tabs (G) on
receptacle against panel.
f.
Insert radio into receptacle and attach radio
bezel.
Ensure radio locks into position and
faceplate (H) is against the panel.
g. Attach stud (supplied with radio) to center rear of
radio.
h. Attach support (D)
to stud on back of
radio chassis with
lock washer and
metric nut (E) that
was supplied with
the
support.
Support
can
attached
chassis in multiple
locations to allow
for proper mounting of radio.
i.
Attach harness included with radio and connect
to windrower harness.
j.
Attach antenna.
k. Reinstall radio panel with original screws.
J
l.
Adjust bracket (J) if necessary by loosening nuts
(K) to allow radio to slide into opening, and
securely capture support (D).
m. Turn ignition key to ACC, switch on the radio
and
check
instructions supplied with the radio.
19
G
H
E
be
to
D
K
operation
in
accordance
Model Year - 2010
D
with
Advertisement
Table of Contents
