Sdi Input Control; Input Status; Sdi Input Control Tab - evertz 570J2K-HW-X19 User Manual

570J2K-HW-X19
Multi channel J2K Encoder-Decoder
5.3.

SDI INPUT CONTROL

Figure 5-7 : WebEASY

- SDI Input Control Tab

®

5.3.1. Input Status

Input Select:
This parameter configures the Max Link Rate for the specified channel path. It is used only when
the channel paths are set for Encapsulation. The user can select the following modes SDI-SD, SDI-HD, 3G-SDI.
When configured to SD the max encapsulation on the link can handle up to 270Mbps. If a HD input is provided,
the signal will be clipped. If the Input select is configured to HD, the max encapsulation on the link can handle up
to 1.5Gbps. If a 3G input is provided the signal will be clipped. When the input select is configured to 3G, the
max encapsulation on the link can handle up to 3Gbps.
Video Standard Detected: This parameter displays the current video standard which is detected.
SDI Loss Count: This parameter displays the SDI loss counter.
Input Alias: This parameter displays the input alias.
Clear SDI Loss Count: This button allows the user to clear the SDI loss counter.
Page - 17
Revision 1.0