Get Dots - Canon REALiS SX6 User Manual

User Command Specifications
1

GET DOTS

GET DOTS
Commands
Function Total number of dots inquiry
GET□DOTS
Format
?△DOTS
Response g:DOTS=<Total number of dots: Number>
For all other responses, refer to "Error List."
Description This inquires about the current total number of dots.
-1
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2 The total number of dots can be set by the DOTS command.
Example > GET DOTS or ? DOTS
< g:DOTS=1200
* Commands are indicated by ">", and responses are indicated by "<".
Commands SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
○
× × ×
SX50
○
SX6
× × ×
SX60
X600
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○
× × ×
○ ○
× × ×
Mode Control Setting Reference
Mode
None Remote
○
– – ×
○
× × ×
PAGE 77
9．Details of command GET DOTS
Number
Remarks
Local
×
×