User Command Specifications
1
BVOL
BVOL
Commands
Function
BEEP sound setting
Format
BVOL=<Beep sound setting: Number>
Parameter
Beep sound setting
Parameter Meaning
0
1
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description
This sets the BEEP sound output.
-1
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2
This command is identical to the Beep function in the System settings menu.
-3
The beep sound can be set even while the sound is muted, but it will not sound even if (beep
sound output) has been set.
-4
The current beep sound output status can be acquired using the applicable GET command.
For details, refer to the GET command.
Example
Setting
> BVOL=0
< i:OK
Reference
> GET BVOL or ?BVOL
<
g:BVOL=1
Acquisition of parameters which can be set
> RANGE BVOL
< r:BVOL=I, 0, 1
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model
Power
OFF ON
PM
D-RGB A-RGB1 A-RGB2 Comp
SX50
×
○
×
○
SX6
×
○
×
○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
BEEP sound mute
BEEP sound output
This mutes the BEEP sound.
This retrieves the BEEP sound output state.
"0" or "1" can be selected as the beep sound setting.
SX6
SX60
X600
01.01**
01.01**
01.01**
○
○
○
Input
Video S-Video D-Video SCART
○
○
○
○
○
○
○
○
○
○
Mode Control Setting Reference
Mode
None
Remote
–
–
○
○
○
○
○
○
PAGE 51
9. Details of command BVOL
ID
Remarks
Local
×
×