Ledilluminate; Commands - Canon REALiS SX6 User Manual

User Command Specifications
1

LEDILLUMINATE

LEDILLUMINATE

Commands

Function Emotional LED and signal sensing LED lighting control
Format LEDILLUMINATE=<LED lighting control setting parameter：ＩＤ>
Parameter LED lighting control setting parameters
Parameter
ON
OFF
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to
Description This command is used to control the lighting of the emotional LED and signal sensing LED.
(1)
It can be executed when the projector is in both the remote mode and power-on status at the same
time.
However, a "busy" response is given while the zoom or focus lens is being driven.
（ Refer to the
(2)
This command functions in the same way as when "System settings" - "LED illumination" are
selected on the menu.
(3)
The current LED illumination setting can be obtained using the GET command.
For details, refer to the
Setting
Example
> LEDILLUMINATE=ON
< i:OK
Reference
> GET LEDILLUMINATE or ?LEDILLUMINATE
<
g:LEDILLUMINATE=ON
Acquisition of parameters which can be set
> RANGE LEDILLUMINATE
< r:LEDILLUMINATE=I, ON, OFF
*Commands are indicated by ">", and responses are indicated by "<".
SX50
Commands
supported ０１．００**
○
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command States
Model Power supply
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
SX50
－ － － －
SX6
× ○ × ○
SX60
X600
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Meaning
This sets the LED display to ON.
This sets the LED display to OFF.
RANGE command
.
"Error List."
ZCONTDRV command and FCONTDRV command.
GET command
.
SX6 SX60 X600
０１．０１** ０１．０１** ０１．０１**
○ ○
Input
Video S-Video D-Video SCART
－ － － － －
○ ○ ○ ○ ○
Mode Control
）
The LED display is set to ON.
The ON or OFF setting for the LED display is
obtained.
"ON" or "OFF" can be set for the LED display.
Mode
None Remote
－ － － －
○ ○ ○ ○
PAGE 64
９．Details of command LEDILLUMINATE
Setting
Reference
ＩＤ
Remarks
Local
－
×