Avol - Canon REALiS SX6 User Manual

User Command Specifications
1

AVOL

AVOL
Commands
Function Audio volume adjustment
Format AVOL=<Audio volume level: Number>
Parameter Audio volume level (0 to 20)
The RANGE command can be used to obtain the parameter range that can be set at
that time.
For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description This adjusts the volume.
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2 The final beep sound setting is retained even when the power is turned off.
-3 This command has the same function as the buttons listed in the table below.
Model
SX50
SX6
SX60
X600
-4 The volume level can be set even while the sound is muted, but the sound will remain muted.
-5 The GET command can be used to retrieve the current volume.
For details, refer to the GET command.
Example Setting
> AVOL=18
< i:OK
Reference
> GET AVOL or ?AVOL
< g:AVOL=18
Obtain settable parameter range (Min, Max)
> RANGE AVOL
< r:AVOL=N,0,20
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
× ×
SX50 ○ ○
SX6 × ×
○ ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Button
'VOL+' and 'VOL-' on the remote control
'VOL' on the remote control
This sets the volume to 18.
This retrieves the volume.
Any value from 0 to 20 can be set for the volume level.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting Reference
Mode
None Remote
– –
○ ○
○ ○ ○ ○
PAGE 49
9. Details of command AVOL
Number
Remarks
Local
×
×