Get Logopos - Canon REALiS SX6 User Manual

User Command Specifications
1

GET LOGOPOS

GET LOGOPOS
Commands
Function User image position inquiry
GET□LOGOPOS
Format
?△LOGOPOS
Response
g:LOGOPOS=<Setting：ＩＤ>
Setting
UPPER_L
UPPER_R
CENTER
LOWER_L
LOWER_R
For all other responses, refer to "Error List."
Description This inquires about the current user screen (logo) display position.
-1
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
-2 An inquiry cannot be made if the user image has not been registered.
(The error "e:1002 NO_LOGO_CAPTURED" is returned.）
-3 The user image position can be set by the LOGOPOS command.
Example > GET LOGOPOS or ? LOGOPOS
< g:LOGOPOS=LOWER_L
* Commands are indicated by ">", and responses are indicated by "<".
Commands SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
○ ○
SX50 × ×
○ ○
SX6
× ×
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Meaning
Upper left
Upper right
Center
Lower left
Lower right
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting Reference
Mode
None Remote
○ ○
– –
○ ○ ○ ○
PAGE 110
9．Details of command GET LOGOPOS
ID
Remarks
Local
×
×