Zstepdrv - Canon REALiS SX6 User Manual

User Command Specifications
1

ZSTEPDRV

ZSTEPDRV
Commands
Function Zoom lens step drive control
Format ZSTEPDRV=<Zoom lens step control parameter：ＩＤ>
Parameter Zoom lens step control parameters
Parameter
WIDE
TELE
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the
Response "i:OK" is returned when zooming was completed successfully after step drive.
For all other responses, refer to
Description This command is used to initiate the step drive of the zoom lens.
(1)
It can be executed when the projector is in both the remote mode and power-on status at the same
time.
However, a "busy" response is given while the zoom or focus lens is being driven.
（ Refer to the
(2)
This command functions in the same way as when first the "ZOOM" button on the remote control or
main unit panel is pressed and then the "←" or "→" button is pressed.
(3)
The amount by which the lens is zoomed is constant, and it is fixed in the system.
(4) If a zooming error occurs, step drive cannot be controlled.
Control
Example
> ZSTEPDRV=TELE
< I:OK
Range acquisition
> RANGE ZSTEPDRV
< r:ZSTEPDRV=I, WIDE, TELE
SX50
Commands
supported ０１．００**
×
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command States
Model Power supply
OFF ON PM
D-RGB A-RGB1 A-RGB2 Comp
SX50
－ － － －
SX6
× ○ × ○
SX60
X600
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Meaning
This zooms to the wide-angle end.
This zooms to the telephoto end.
RANGE command
.
"Error List."
ZCONTDRV command and FCONTDRV command.
1-step control is exercised over the zoom toward the TELE end.
"WIDE" or "TELE" can be set as the step control of the zoom.
SX6 SX60 X600
０１．０１** ０１．０１** ０１．０１**
○ ○ ○
Input
Video S-Video D-Video SCART
－ － － － －
○ ○ ○ ○ ○
Mode Control Setting
）
Mode
None Remote
－ － － －
○ ○ ○ ○
PAGE 65
９．Details of command ZSTEPDRV
Reference
ＩＤ
Remarks
Local
－
×