Rcch - Canon REALiS SX6 User Manual

User Command Specifications
1

RCCH

RCCH
Commands
Function Remote control setting
RCCH=<Remote control setting parameters：ＩＤ>
Format
Parameter Remote control setting parameters
Parameter Meaning
1
2
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description This command is used to set the channel of the remote control used at the projector end to 1 or 2.
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2
This command is identical to the Remote control function in the System settings menu.
Model
SX50
SX6
SX60
X600
-3
The current remote control setting can be acquired using the applicable GET command.
For details, refer to the GET command.
Example Setting
> RCCH=1
< i:OK
Reference
> GET RCCH or ?RCCH
< g:RCCH=2
Acquisition of parameters which can be set
> RANGE RCCH
< r:RCCH=I, 1, 2
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
× ×
SX50 ○ ○
SX6 × ×
○ ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Remote control channel 1
Remote control channel ２
Menu
[System settings] - [Remote control]
[System settings] - [Other settings] - [Remote control]
This sets the remote control channel to ch1.
This retrieves the remote control setting state.
"1" or "2" can be set as the remote control channel.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting Reference
Mode
None Remote
– –
○ ○
○ ○ ○ ○
PAGE 61
9. Details of command RCCH
ID
Remarks
Local
×
×