Get Hpix/Vpix - Canon REALiS SX6 User Manual

User Command Specifications
1

GET HPIX/VPIX

GET HPIX/VPIX
Commands
Function Horizontal and vertical resolution inquiries
Format
Horizontal resolution inquiry
GET□HPIX
?△HPIX
Response
g:HPIX=<Horizontal resolution: Number>
g:VPIX=<Vertical resolution: Number>
For all other responses, refer to "Error List."
Description These inquire about the current horizontal and vertical resolutions.
-1 This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2
The horizontal and vertical resolutions can be set using the HPIX and VPIX commands,
respectively.
Example > GET VPIX or ? VPIX
< g:VPIX=684
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM
D-RGB A-RGB1 A-RGB2 Comp
○ ○
SX50 × ×
SX6 ○ ○
× ×
SX60
X600
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Vertical resolution inquiry
GET□VPIX
?△VPIX
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○
× × ×
○ ○
× × ×
Mode Control Setting
Mode
None Remote
○
– – ×
○
× × ×
PAGE 80
9．Details of command GET HPIX/VPIX
Reference
Number
Remarks
Local
×
×