Cont - Canon REALiS SX6 User Manual

User Command Specifications
1

CONT

CONT
Commands
Function Contrast setting
Format CONT=<Contrast setting: Number>
Parameter Contrast setting (-20 to 20)
The RANGE command can be used to obtain the parameter range that can be set at
that time.
For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description This sets the screen contrast.
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2 This command is the same as the menu functions in the table below.
Model
SX50
SX6
SX60
X600
-3 The currently selected input signal and image mode are used for these settings.
-4 The current contrast can be acquired using the applicable GET command.
For details, refer to the GET command.
Example Setting
> CONT=3
< i:OK
Reference
> GET CONT or ?CONT
< g:CONT=3
Obtain settable parameter range (Min, Max)
> RANGE CONT
< r:CONT=N, -20, 20
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
× ×
SX50 ○ ○
SX6 × ×
○ ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Menu
[Image adjustments] - [Contrast]
[Image adjustments] - [Contrast]
This sets the contrast to +3.
This retrieves the contrast.
Any value from -20 to 20 can be set for the contrast.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting Reference
Mode
None Remote
– –
○ ○
○ ○ ○ ○
PAGE 30
9. Details of command CONT
Number
Remarks
Local
×
×