Power Management Mode - Canon REALiS SX6 User Manual

User Command Specifications

1 7. Power Management Mode

7. Power Management Mode
Concerning the processing for switching to the power management standby or exit mode in the remote or local mode
Mode
Remote The power management standby or exit mode is
not established.
(No countdown is initiated.)
Local The power management standby or exit mode is established when no signals are supplied for at least 5
minutes.
Projecting in
progress
Lamp off
Power Off
SX50
The power management standby or exit mode is
established when no signals are supplied for at least 5
The countdown is aborted by any command other than
GET/RANGE.
Control is switched to the "local mode" in the standby or
exit mode.
Lamp on
Lamp
When the standby
cooling in
mode is established
progress
When the exit mode is established
PAGE 11
SX6/SX60/SX600
Events for returning from standby mode
・Signal input
・Pressing of a button on main unit or remote control
・REMOTE command
・RC/MAIN command (excluding RC/MAIN*-REP)
Power management activated
Processing only for commands
enabled in power management
standby mode
7. Power Management Mode