Zcontdrv - Canon REALiS SX6 User Manual

User Command Specifications
1

ZCONTDRV

ZCONTDRV
Commands
Function Zoom lens continuous drive control
Format ZCONTDRV=<Zoom lens continuous control parameter：ＩＤ>
Parameter Zoom lens continuous control parameters
Parameter
STOP
WIDE
TELE
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the
Response "i:OK" is returned when the drive was completed successfully.
For all other responses, refer to
Description This command is used to drive the zoom lens continuously.
(1) It can be executed when the projector is in both the remote mode and power-on status at the same
time.
However, only the "STOP" parameter takes effect while the zoom lens is being driven, and a "busy"
response is given while the focus lens is being driven.
（ Refer to the
(2) This command functions in the same way as when first the "ZOOM" button on the remote control or
main unit panel is pressed and then the "↑" or "↓" button is pressed.
(3) Zoom drive is started by specifying "TELE" or "WIDE." To stop the drive, add the "STOP"
parameter and send this command.
If no instruction was given to stop the drive, the drive stops at the drive direction end.
(4) The following commands are acknowledged during zoom drive, but zoom drive will also stop at the
same time.
In the case of any other commands, "i:BUSY (ZOOM)" is returned unconditionally, and zoom drive
continues.
a. REMOTE
b. LOCAL
c. POWER
d. ZCONTDRV=STOP
(5) The following commands are acknowledged during zoom drive, and a response is returned while the
drive continues.
a. GET MODE
b. GET POWER
c. GET ERR
d. GET LAMPCOUNTER
(6)
Zoom drive stops when the "POWER" button on the remote control or main unit panel is pressed
during zoom drive.
Example Control
> ZCONTDRV=TELE
< I:OK
Range acquisition
> RANGE ZCONTDRV
< r:ZCONTDRV = I, STOP, WIDE, TELE
SX50
Commands
supported ０１．００**
×
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command States
Model Power supply
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
SX50
－ － － －
SX6
× ○ × ○
SX60
X600
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Meaning
This stops the zooming.
This zooms to the wide-angle end.
This zooms to the telephoto end.
RANGE command
.
"Error List."
FCONTDRV command.
e. GET PRODCODE
f. GET ROMVER
g. GET COMVER
SX6 SX60 X600
０１．０１** ０１．０１** ０１．０１**
○ ○ ○
Input
Video S-Video D-Video SCART
－ － － － －
○ ○ ○ ○ ○
Mode Control Setting
）
Control over the zooming to the telephoto end is started.
"STOP," "WIDE" or "TELE" can be set for zoom lens
continuous drive.
Mode
None Remote
－ － － －
○ ○ ○ ○
PAGE 66
９．Details of command ZCONTDRV
Reference
ＩＤ
▼
Remarks
Local
－
×