User Command Specifications
1
MUTE
MUTE
Commands
Function
Mute control
Format
MUTE=<Mute control parameter: ID>
Parameter
Mute control parameter
Parameter Meaning
ON
OFF
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description
This command is used to set the sound output muting to ON or OFF.
-1
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2
The mute setting is always "OFF" when the power has just been turned on.
-3
This command is identical to pressing the MUTE button on the remote control.
-4
Mute control enables simultaneous control of the audio and beep sound.
-5
The current muting status can be acquired using the applicable GET command.
For details, refer to the GET command.
Example
Setting
> MUTE=ON
< i:OK
Reference
> GET MUTE or ?MUTE
<
g:MUTE=ON
Acquisition of parameters which can be set
> RANGE MUTE
< r:MUTE=I, ON, OFF
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model
Power
OFF ON
PM
D-RGB A-RGB1 A-RGB2 Comp
SX50
×
○
×
○
SX6
×
○
×
○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
This turns off the audio/beep sound.
This returns the audio/beep sound to its original setting.
This mutes the volume.
This retrieves the volume state.
"ON" or "OFF" can be set for muting control.
SX6
SX60
X600
01.01**
01.01**
01.01**
○
○
○
Input
Video S-Video D-Video SCART
○
○
○
○
○
○
○
○
○
○
Mode Control Setting Reference
Mode
None
Remote
–
–
○
○
○
○
○
○
PAGE 50
9. Details of command MUTE
ID
Remarks
Local
×
×