Canon REALiS SX6 User Manual page 78

User Command Specifications
Response "i:OK" is returned when the button press request has been acknowledged successfully.
(It does not indicate if the operation for the pressed button was executed properly.)
Description This emulates pressing of the remote control buttons for controlling the projector.
-1 It can only be used during Local mode.
■ Note 1
With the emulation of the remote control operations, the functions of the buttons corresponding
to the parameters cannot necessarily be executed.
Emulation simply consists in emulating the pressing of the buttons.
■ Note 2
The following functions are unavailable in remote control emulation.
- USB mouse function
- Function for transfer to special mode (service mode)
■ Note 3
A parameter with '+REP' signifies "button press start." (This is the same as the status in which
the remote control button is held down.)
Be absolutely sure to send the '*-REP' parameter, and end the button pressing last of all.
The button pressing is ended in the cases below as well.
<1> When a panel or remote control button has been operated
<2> When an 'RC' or 'MAIN' command has been received
<3> When operation has transferred to the remote mode
Example Setting
> RC POWER
< i:Ok
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
SX50 ○ ○ ○ ○
SX6
○ ○ ○ ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' is returned as an error response.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode
None Remote
– – ×
○
×
○ ○ ○
PAGE 70
9. Details of command RC
Remarks
Local
○
○