Logopos - Canon REALiS SX6 User Manual

User Command Specifications
1

LOGOPOS

LOGOPOS
Commands
Function User image position setting
LOGOPOS=<User image position setting parameters：ＩＤ>
Format
Parameter User image position setting parameters
Parameter
UPPER_L
UPPER_R
CENTER
LOWER_L
LOWER_R
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description This sets the logo display position.
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2 This command is the same as the menu functions in the table below.
Model
SX50
SX6
SX60
X600
-3 This setting cannot be made unless the user screen is registered beforehand.
(Error "e:1002 NO_LOGO_CAPTURED" is returned.)
-4 The current display position can be acquired using the applicable GET command.
For details, refer to the GET command.
Example Setting
> LOGOPOS=UPPER_R
< i:OK
Reference
> GET LOGOPOS or ?LOGOPOS
< g:LOGOPOS=LOWER_L
Acquisition of parameters which can be set
> RANGE LOGOPOS
< r:LOGOPOS=I,UPPER_L,UPPER_R,CENTER,LOWER_L,LOWER_R
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
SX50 × ○ × ○
SX6
× ×
○ ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Meaning
Upper left
Upper right
Center
Lower left
Lower right
Menu
[Display settings] - [User screen settings] - [User image position]
[Display settings] - [User screen settings] - [User image position]
This sets the logo display position to the upper right.
This retrieves the logo display position.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting
"UPPER_L," "UPPER_R,"
"CENTER," "LOWER_L" or
"LOWER_R" can be set as the
user image position.
Mode
None Remote
– – ○ ○
○ ○ ○ ○
PAGE 57
9. Details of command LOGOPOS
Reference
ID
Remarks
Local
×
×