Adjusting the Total Number of Dots
[Total dots]
ANALOG PC
You can select the total number of dots in the
horizontal direction. Adjust the number of dots
when the image distorts or noise is displayed on
the screen at both sides.
Display settings
Input signal select
Total dots
Increases the total number of dots.
>
<
Decreases the total number of dots.
Press the [MENU] button when you finish.
Perform this adjustment if the auto PC
adjustment function cannot adjust the
project image correctly.
The setting is recorded for [ANALOG
PC-1] and [ANALOG PC-2] sepa-
rately.
Adjusting the Tracking
[Tracking]
ANALOG PC
You can fine-tune the timing for generating an
image from the image signal. Adjust the tracking
when the image flickers or distorts.
Display settings
Input signal select
Tracking
Increases the set value.
>
<
Decreases the set value.
Press the [MENU] button when you finish.
Perform this adjustment if the auto PC
adjustment function cannot adjust the
project image correctly.
The setting is recorded for [ANALOG
PC-1] and [ANALOG PC-2] sepa-
rately.
Setting Display Status
91