Canon REALiS SX6 User Manual page 44

User Command Specifications
1
WB
WB
Commands
Function Screen color correction
WB=<Screen color correction parameters：ＩＤ>
Format
Parameter Screen color correction parameters
Parameter
NORMAL
GREENBOARD
ADJUST
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description The screen color correction is set to "Normal", "Blackboard", or "Adjust".
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2 This command is the same as the menu functions in the table below.
Model
SX50
SX6
SX60
X600
-3
When "ADJUST" has been selected, adjust the RGB adjustment values using the WBRGB
command.
-4 When the model SX50 is used, the currently selected input signal and image mode settings are
established.
When the model SX6, SX60 or X600 is used, a set of settings is established for the system.
-5 The current screen color correction can be acquired using the applicable GET command.
For details, refer to the GET command.
Example Control
> WB=NORMAL
<
i:OK
Reference
> GET WB or ?WB
< g:WB=GREENBOARD
Acquisition of parameters which can be set
> RANGE WB
<
r:WB=I,NORMAL,GREENBOARD,ADJUST
* Commands are indicated by ">", and responses are indicated by "<".
Commands SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
SX50 × ○ × ○
SX6
× ○ × ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Meaning
Standard
Blackboard
Adjust
Menu
[Image adjustments] - [Screen color correction]
[Display settings] - [Screen color correction]
This sets the screen color correction to "Normal".
This retrieves the screen color correction.
"NORMAL," "GREENBOARD" or "ADJUST" can be
set for the screen color correction.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting Reference
Mode
None Remote
– – ○ ○
○ ○ ○ ○
PAGE 36
9. Details of command WB
ID
Remarks
Local
×
×