Image - Canon REALiS SX6 User Manual

User Command Specifications
2

IMAGE

IMAGE
Commands
Function Image mode setting
IMAGE=<Image mode setting parameter：ＩＤ>
Format
Parameter Image mode setting parameters
Parameter
STANDARD
PRESENTATION
CINEMA
SRGB
ADOBE
MOVIE
MOVIE_PHOTO
HOME_CINEMA
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
"i:OK" is returned if the parameter was set properly.
Response
For all other responses, refer to "Error List."
Description This sets the image quality.
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2 The final settings for the image mode are retained even when the power is turned off.
-3 This command is the same as the menu functions in the table below.
Model
SX50
SX6
SX60
X600
-4 Changing the setting may modify the following setting values.
Brightness
Contrast
Sharpness
Gamma adjustment
Dynamic gamma
Progressive
Screen color correction/RGB
adjustment values
Saturation/hue
Advanced color adjustment
Memory color correction
RGB gain/offset adjustments
6-axis color adjust
-5 The current image quality can be acquired using the applicable GET command.
For details, refer to the GET command.
Example Setting
> IMAGE=PRESENTATION
< i:OK
Reference
> GET IMAGE or ?IMAGE
< g:IMAGE=CINEMA
Acquisition of parameters which can be set
> RANGE IMAG
< r:IMAGE=I, STANDARD, CINEMA, SRGB
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Errors supported by model
Meaning
SX50
Standard ○
Presentation
○
Cinema
○
○
sRGB
ADOBE RGB ×
Movie ×
Movie & Photo ×
×
Home theater
Menu
[Image adjustments] - [Image mode settings]
[Image adjustments] - [Image mode settings]
Commands related to the
Setting
BRI
CONT
SHARP
GAMMA
DGAMMA
PROG
WB/ WBRGB
SAT/ HUE
ACADJUST
MEMCADJ
RGBGAIN/RGBOFFSET
6AXR～Y
This sets the image mode to "Presentation."
This references the current image mode.
"STANDARD," "CINEMA" or "SRGB" can be set as
the image mode.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Mode Control Setting
SX6 SX60 X600
○ ○ ○
○ ○ ○
× × ×
○ ○ ○
× ×
○
×
○ ○
× ×
○
× ×
○
Remarks
settings
For the SX50
For the SX50
For the SX6, SX60 or X600
For the SX6, SX60 or X600
PAGE 27
9. Details of command IMAGE
Reference
ID