Range Hue - Canon REALiS SX6 User Manual

User Command Specifications
1

RANGE HUE

RANGE HUE
Commands
Function Hue setting range request
RANGE□HUE
Format
Response r:HUE=N, <Minimum setting value>, <Maximum setting value>
For all other responses, refer to "Error List."
Description This inquires about the range within which the hue can be set.
-1
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
With some input signals, it may not be possible to make this inquiry.
-2 The hue can be set by the HUE command.
Example > RANGE HUE
< r:HUE=N, -20, 20
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
○
SX50 × × ×
SX6
○
SX60 × × ×
X600
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video SCART
○
– –
× ×
○ ○
–
○
– –
× ×
○ ○
–
Mode Control Setting Reference
Mode
None Remote
○
○
– –
×
○
○
× ×
×
PAGE 148
9．Details of command RANGE HUE
Number
Remarks
Local
×
×