Control Mode - Canon REALiS SX6 User Manual

User Command Specifications

1 5. Control Mode

5. Control Mode
The table below shows the states and limitations of the LOCAL and REMOTE control modes.
Mode
Item
Description
Status
LED
ALM
Transition method
Main unit keys All available
Operation Remote control
buttons keys
Emulation
Switching
Power
management
standby and exit
modes
※3
Return
Commands supported
Special mode
(Service mode)
*1 However, switching to the USB mouse function or Special mode is not allowed.
*2 If the control mode is REMOTE, the following are displayed regardless of whether the power is on or off.
*3 When the power management setting is "standby" or "exit"
LED indicator pattern during REMOTE mode
■ ■
LOCAL mode
Mode where projector control/operation is
performed by the main unit or remote control.
Initial mode when microcomputer is started.
State indicator
ALM state indicator
・AC power supply to projector
・Manual power on/off
・LOCAL command
・Power management standby/exit mode transfer
All available
Available ※1
5 minutes elapsed from no signal
・Signal input
・Remote control button pressed
・Main unit button pressed
・Emulation
For the SX50
Command/parameter
REMOTE
LOCAL
GET MODE
MAIN
RC
For the SX6, SX60 or X600
Command/parameter
GET COMVER
GET ERROR
GET FREEZE
GET INPUT
GET LAMPCOUNTER
GET MODE
GET MUTE
GET NOSHOWSTATUS
GET POWER
GET PRODCODE
GET ROMVER
GET SIGNALSTATUS
LOCAL
MAIN
RC
REMOTE
Executable with remote control or main unit buttons Not executable in any state
Mode where projector control/operation is
performed by a PC or other external device.
(The PC or other external device is connected by
a serial cable.)
Constant remote indicator ※2
ALM state indicator
・REMOTE command
Only POWER button is available
Only POWER button is available
Not available
Operation is as follows depending on the model.
Model
・
No switching to standby or exit
SX50
mode.
・ 5 minutes elapsed from no
SX6
signal
SX60
・ Control is switched to "local
X600
mode" after mode switching.
・REMOTE command
All commands except for "RC" and "MAIN"
Remarks
Remarks
PAGE 9
5. Control Mode
REMOTE mode
Operation