Noshow - Canon REALiS SX6 User Manual

User Command Specifications
1

NOSHOW

NOSHOW
Commands
Function Display screen setting when nothing shown
NOSHOW=<Parameters for setting display screen in no show status ：ＩＤ>
Format
Parameter Parameters for setting display screen in no show status
Parameter
BLACK
BLUE
LOGO
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Response "i:OK" is returned if the parameter was set properly.
For all other responses, refer to "Error List."
Description This command is used to set the screen which is to appear in the no show status.
-1 It can be executed when the projector is in both the remote mode and power-on status at the
same time.
A "busy" response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
-2 This command is the same as the menu functions in the table below.
Model
SX50
SX6
SX60
X600
-3 To select the user screen (LOGO), the user image must be registered ahead of time. (If the
user image is not registered, "e:1002 NO_LOGO_CAPTURED" is returned.)
-4 The GET command can be used to obtain the current display screen when nothing is shown.
For details, refer to the GET command.
Example Setting
> NOSHOW=LOGO
< Ok
Reference
>
GET NOSHOW or ?NOSHOW
< g:NOSHOW=LOGO
Acquisition of parameters which can be set
> RANGE NOSHOW
< r:NOSHOW=BLACK,BLUE,LOGO
* Commands are indicated by ">", and responses are indicated by "<".
Commands
SX50
supported
01.00**
○
Supported Command States
Model Power
OFF ON PM D-RGB A-RGB1 A-RGB2 Comp
× ×
SX50 ○ ○
SX6
× ○ × ○
SX60
X600
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Meaning
Black screen
Blue screen
User screen
Menu
[Display settings] - [User screen settings] - [Screen in no show status]
[Display settings] - [User screen settings] - [Screen in no show status]
This sets the "User" screen when nothing is displayed.
This retrieves the screen shown when nothing is displayed.
"BLACK," "BLUE" or "LOGO" can be set for the display
screen in the no show status.
SX6 SX60 X600
01.01** 01.01** 01.01**
○ ○ ○
Input
Video S-Video D-Video
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Mode Control Setting
Mode
SCART None Remote
– –
○ ○
○ ○ ○ ○
PAGE 56
9. Details of command NOSHOW
Reference
ID
Remarks
Local
×
×