Table of Contents
Advertisement
Menu Settings
Serial communication
> [System settings] >
You can check setting values for the service port (CONTROL) used for serial
communication.
Option
Stop bit
Baud rate
Data bits
Parity
Power management mode
> [System settings] >
You can specify to turn off the lamp or projector automatically after a certain period
if the projector and remote control are not used and there is no input signal.
Option
Disabled
Lamp off
Standby
• After the lamp is turned off, projection resumes when:
-
the same input signal is restored.
-
the remote control or projector is operated.
-
the power is turned on.
• After the projector enters standby, restoring projection requires the same steps as when
turning the projector on normally.
• When [Disabled] is selected, [Direct power on] (P115) is not available.
Power management duration
> [System settings] >
Specify how long before the lamp is turned off or the projector enters standby,
depending on the [Power management mode] setting.
Option
5 min. - 60 min.
• If conditions that would start countdown are met while you are blanking projection,
blanking is canceled.
• Once countdown begins, audio output stops.
[Serial communication]
Length of mark representing the end of data bits.
Modulation rate, in bits per second.
Number of bits of data.
Number of parity bits.
[Power management mode]
Disable power management mode.
Only turns the lamp off.
Turns the projector off and puts it in standby.
[Power management duration]
After 30 seconds without an input signal when the projector is idle,
the projector starts displaying a countdown of the selected time.
114
Function
Function
Function
Advertisement
Table of Contents
