Selecting A Logo At Startup; Specifying Power Management Mode - Canon WUX6000 User Manual

Customizing System Operation (System Settings)
Selecting a Logo at
Startup
> [System settings] > [User screen
settings] >
HDMI
Digital PC
You can display a specified logo on
the screen from the moment the
projector is turned on to the moment
it is ready for projection.
Skip Projects an input signal
immediately after turning on
the projector.
Canon Displays the Canon logo that
logo was registered in advance at
the factory.
User logo The user logo is projected.
Press the OK button to accept your
setting and then press the MENU
button.
• [Canon logo] is the factory default.
Downloaded from ProjectorsManual.com Manuals
[Projector on]
Component LAN
Analog PC USB
Specifying Power
Management Mode
> [System settings] >
management mode]
HDMI
Digital PC
You can specify to turn off the lamp
or projector automatically after a
certain period if the projector and
remote control are not used and
there is no input signal.
Disabled Disable power management
mode.
Lamp off Only turns the lamp off.
Standby Turns the projector off and puts
it in standby.
Press the OK button to accept your
setting and then press the MENU
button.
• [Standby] is the factory default.
• After the lamp is turned off, projection
resumes when the same input signal is
restored, or when the remote control or
projector is operated.
• After the projector enters standby, restoring
projection requires the same steps as when
turning the projector on normally.
• When [Disabled] is selected, [Direct power
on] (P99) is not available.
98
[Power
Component LAN
Analog PC USB