Quick Startup; Power Management Mode - Canon 4K600STZ User Manual

Standby power setting
Specify network function operating status in standby mode.
Option
All network functions are available when network functions are
Normal
enabled, including the web screen and PJLink.
All network functions are available even in standby mode.
Low-power However, the projector may be less responsive than usual when some
functions are initially used.
• If [Low-power] is selected, some features may take a long time to access on the
network. For quicker access, select [Normal].
• [Standby power setting] is not available when [Quick startup] is set to [On].
• [Standby power setting] is set to [Normal] and cannot be changed when scheduling
is enabled (P130).
• [Standby power setting] is set to [Normal] and cannot be changed when wireless
LAN is enabled (P137). (4K600STZ/4K600Z)

Quick startup

Enable faster startup next time by leaving some circuits on for 90 minutes after the projector
is turned off. However, to avoid sudden surges in intensity, projection is delayed by at least
approximately 1.7 seconds.
Option
Off Disable quick startup.
On Enable quick startup.

Power management mode

Specify to turn the light source off or enter standby if there is no input signal. This feature
automatically turns off the light source or power after a certain period if the remote control or
projector is not operated.
Option
Disabled Disable power management mode.
Light source off Only turns the light source off.
Standby Turns the projector off and puts it in standby.
• Projection resumes when the same input signal is restored, when the remote control
or projector is operated, or when user commands are sent to turn the projector on.
• After the projector enters standby, restoring projection requires the same steps as
when turning the projector on normally.
• When [Disabled] is selected, [Direct power on] is not available.
Function
Function
Function
125
Menu Settings