YASKAWA Sigma-V Series User Manual page 42

2 Parameter/Monitor Modes
2.2.3 Parameter Display and Setting
Step
7
8
9
Note: The following parameters set in constants are validated after setting validation. For more
(5) When validating Parameter Setting
2-18
Display Example
− P R M / M O N −
B B
P n 3 0 4 = 0 0 5 0 0
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
− P R M / M O N −
B B
P n 3 0 4 = 0 1 0 0 0
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
− P R M / M O N −
B B
P n 3 0 4 = 0 1 0 0 0
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
information on parameters, refer to manuals listed in
• Pn20E (Electronic gear ratio (Numerator))
• Pn210 (Electronic gear ratio (Denominator))
• Pn205 (Multiturn limit setting)
• Pn50A (Input signal selection)
The parameters that do not require turning OFF the power and turning ON to
validate the setting, are validated immediately. For example, when using
the and Keys while changing the gain, the change is reflected in the
motion immediately. However, the change is not saved in the SERVOPACK at
this moment. Press the
If another mode display is selected with the
the setting side by pressing the
changes in the setting will not be saved in the SERVOPACK.
Press the
to the third digit of Pn304.
Press the
setting to "1000."
Press the
The setting value is written to the SERVO-
PACK, and the cursor moves to the parameter
number side.
Key to save the change in the SERVOPACK.
Key, or the cursor is moved on
Key before pressing the
Description
Key twice to move the cursor
Key five times to change the
Key.
Related Manuals on page iv.
Key, the