YASKAWA Sigma-V Series User Manual page 37

• and Keys
When the cursor is on "Un" or "Pn" on the left side (parameter number side),
press the
the parameter number "Pn."
U n 0 0 0 = 0 0 0 0 0 0
When the cursor is on a numeric character on the left side (parameter number
side), press the
respective setting.
Function selection basic switch 0
Function selection application switch 1
Function selection application switch 2
Function selection application switch 6
Regenerative resistor capacity
When the cursor is on the right side (the setting side), press
the or
position.
P n 0 0 0 = n. 0 0 0 0
• Key
Press this key to switch the cursor position between the parameter number and
the setting.
P n 0 0 0 = n. 0 0 0 0
After having changed the setting, press the
the SERVOPACK.
or Key to switch the monitor mode number "Un" to/from
or Key to change the parameter number and display
P n 0 0 0 = n. 0 0 0 0
P n 0 0 1 = n. 0 0 0 0
P n 0 0 2 = n. 0 0 0 0
P n 0 0 6 = n. 0 0 0 2
P n 6 0 0 = 0 0 0 0 0
Key to increase or decrease the numerical value of the cursor
P n 0 0 0 = n. 0 0 0 1
P n 0 0 0 = n. 0 0 0 0
2.2 Parameter Mode
,
P n 0 0 0 = 0 0 1 0
Key to write the new setting in
2
2-13