YASKAWA Sigma-V Series User Manual page 158

Step Display Example
B B
0 0 : S G D V − R 7 0
R e a d i n g
5
P a r a m e t e r s . .
< < O P > >
A . 9 4 1
0 0 : S G D V − R 7 0
6
C o m p l e t e d
A . 9 4 1
0 0 : S G D V − R 7 0
7
0 1 : ∗ ∗ ∗ ∗
0 2 : ∗ ∗ ∗ ∗
0 3 : ∗ ∗ ∗ ∗
A . 9 4 1
1 : S E R V O → O P
8
2 : O P → S E R V O
3 : V E R I F Y
4 : L I S T
− O P → S E R V O −
− O P → S E R V O −
− O P → S E R V O −
− C O P Y −
4.3 Write-in Parameters (OP → SERVO)
Description
Execute writing the parameters.
Press the Key to start writing param-
eters into the SERVOPACK.
Note: While the power to the servomotor is
ON (RUN) and the Write Prohibited
Setting (Fn010 = 0001) is set,
the Key is disabled and "Not
Available" is displayed if it is pressed.
Writing completion
When the parameters were read out from the
specified block in digital operator, and saved
in the SERVOPACK, "Completed" is dis-
played.
And A.941 "Change of Parameters Requires
the Setting Validation" is displayed.
Return to the parameter block selection dis-
play.
When the parameters were written and saved,
"Completed" is displayed, and then the
parameter block selection display appears.
To the Parameter Copy Mode menu display
Press the Key.
The display returns to the Parameter Copy
Mode menu display.
Turn OFF the power and turn ON again to
clear A.941.
4
4-9