Pairing An Srx2/Srx3 Headset; Pairing An Srx2/Srx3 Headset With An A700/A700X Device Using Touchconnect - Honeywell SRX2 User Manual

Screen-Based pairing
See Screen-Based Pairing information in this chapter for details on pairing
handheld devices to a headset.

Pairing an SRX2/SRX3 Headset

The SRX2 and SRX3 headsets make pairing and connecting even easier:
Pairing an SRX2/SRX3 Headset with an A700/A700x
Device Using TouchConnect™
The A700/A700x device can use TouchConnect to connect to an SRX2/SRX3 Wireless
Headset when:
l
l
l
l
l
l
For best performance when using an SRX2 or SRX3 headset with a Talkman
A700 or A700x device, use the latest headset software version. Obtain the latest
headset software from your Honeywell portal or reseller and use the Honeywell
Accessory Update Utility to upgrade your headset.
NOTE
Data sent through near field communication (NFC) is not encrypted nor does it fol-
low any specific safety protocol. This is because the transfer occurs over such a short
range that it is extremely unlikely that the data could be intercepted.
1. Turn on the headset.
2. If the headset's LED is blinking blue, it is currently paired to a device. Clear
39
The headsets automatically enter low power pairing mode
l
when it is turned on.
The headsets can break and re-enter pairing modes from a
l
powered-on state.
No headset reboot is necessary.
l
The headsets accept connections from any device that was
l
previously paired to it.
the A700/A700x device is running VoiceCatalyst
Bluetooth is enabled
the device is sleeping (not running a task)
a wired headset is not attached or a wireless headset is not actively
connected to the device
the parameter SRXHeadsetEnable is set to 1 (Enabled), the default
the parameter SrxAutoPairEnable is set to 0 (Disabled), the default
the pairing by pressing the + and - buttons simultaneously on the headset.
You must first obtain the operator ID by reading the headband:
If you are
sharing
1. Touch area of the headset t-bar
SRX3 User Guide - Preliminary