Storing The Srx3 Hard-Hat Headset; Replacing An Earpad On The Srx3 Hard-Hat Or High-Noise Headset - Honeywell SRX3 User Manual

Storing the SRX3 Hard-Hat Headset

Honeywell recommends storing the hard hat with the headset earcup moved up
on the side of the hat (see figure below) to reduce the risk of damage.
1. Remove the electronics module from the headset. The electronics module
can be used by another worker or stored separately.
2. Detach the microphone cap from the electronics module, and dock it in the
mic cap pocket located above the headset earcup.
3. Pull the earcup and fork assembly out away from the hard hat until the fork
snaps into the outer lock position.
4. Rotate the headset n the hard-hat clip until the earcup rests against the side
of the hat.
Replacing an Earpad on the SRX3 Hard-Hat
or High-Noise Headset
1. Remove the electronics module from the earcup.
2. Pry the earcup apart by grasping the inside and outside sections of the
earcup and pulling the two sections apart.
27 SRX3 User Guide - Preliminary