Reading Setpoint2 Value; Writing Setpoint1 Value; Writing Setpoint2 Value; Reading Mode Setting - Ulvac G-TRAN Series Instruction Manual

Reading Setpoint2 Value

Command : AD0
Return format from this unit to PC.
： AD0 AD1 2

"X.XXE±XX" contains the setpoint value. "±" can be "+" or "-".

Writing setpoint1 value

command : AD0

"X.XXE±XX" contains the setpoint value. "±" can be "+" or "-".
 From 5.00E-08 to 1.00E+05 can be set. If setting a value lower than 5.00E-08,
the value is set to 5.00E-08. If setting a value higher than 1.00E+05, the
value is set to 1.00E+05.

If the command is received normally, 'o' is returned.

Writing setpoint2 value

Command : AD0

"X.XXE±XX" contains the setpoint value. "±" can be "+" or "-".

From 5.00E-08 to 1.00E+05 can be set. If setting a value lower than 5.00E-08,
the value is set to 5.00E-08. If setting a value higher than 1.00E+05, the
value is set to 1.00E+05.

If the command is received normally, 'o' is returned.

Reading mode setting

Command : AD0
Return format from this unit to PC.
： AD0 AD1 MDR
 "n" indicates the following:
「2」: Mode 2 (automatic recognition mode)
「3」: Mode 3 (old output mode：ISG1 S/N:0000 to 04049)
「9」: Mode 9 (BMR2 compatibility mode)

Writing mode setting

Command : AD0

"n" indicates the following:
「2」: Mode 2 (automatic recognition mode)
「3」: Mode 3 (old output mode：ISG1 S/N:0000 to 04049)
「9」: Mode 9 (BMR2 compatibility mode)

If the command is received normally, 'o' is returned.

Reading address setting

Command : AD0
Return format from this unit to PC.
： AD0 AD1 4AR
"n n" is the set value.
AD1 2R
X . X X
AD1 1W X .
AD1 2W X .
AD1 MDR
n CHKH CHKL
AD1 MDW n CHKH
AD1 4AR
n n CHKH CHKL
41
CHKH CHKL CR
E ± X X
X X E ± X
X X E ± X
CHKH CHKL CR
CR
CHKL CR
CHKH CHKL CR
CR
CHKH CHKL CR
X CHKH CHKL CR
X CHKH CHKL CR