Dedicated Application - Ulvac G-TRAN Series Instruction Manual

1.

Dedicated application

SH200 and ST200 series can check various settings and status using the dedicated
applications below.
Please refer to the application instruction manual for details.
・UL-MOBI_Windows (Supported OS: Windows 10 64bit or later)
・UL-MOBI_Andoroid (Supported OS: Android 6.0 or later)
Download: UL-MOBI_Android Google Play
UL-MOBI_Windows
UL-MOBI_Windows Instruction manual
Function
DATA
DATA LOG
SAMPLING
FIL･DEGAS
Pressure unit
SETPOINT 1/2/3
Baud rate
Mode
Address
ATM point
adjust
Adjust clear
Status
New password
◎：It can be checked and changed at any time
〇：It can be checked at any time. A password is required in order to change
when energized at 24V.
●：It can be checked at any time. It can be changed only when 24V is cut off.
△：It can be done only when energized at 24V.
▲：It can be done only when energized at 24V. A password is required.
※A password is required to change the settings, as careless setting change may cause
the failure of the vacuum system.
The password can be set to any four numbers.
※The software of this unit uses the pressure unit [Pa].
When changing the pressure unit on UL-MOBI, UL-MOBI converts the pressure unit to
[Pa] and writes it to this unit.
Please note that rounding errors may occur when converting units.
https://www.ulvac.co.jp/download/en/application/
https://www.ulvac.co.jp/download/en/application/
Note
Check the pressure numerically and draw a
graph.
Pressure indication value LOG and CSV
output.
Check and change the sampling cycle.
Display filament and DEGAS status.
Change the pressure unit.
Check and change of setpoint.
Check and change of baud rate.
Check and change of mode.
Check and Change of address.
Adjusts the atmospheric pressure of SAU
and SWU.
Reset the zero point and atmospheric
pressure adjustment of SAU and SWU.
Display errors.
Changes a password.
1
UL-MOBI UL-MOBI
Windows Android
△ △
◎ ◎
◎ ◎
◎ ◎
◎ ◎
〇 〇
● ●
● ●
● ●
▲ ▲
▲ ▲
△ △
◎ ◎