5. Verify that cables are properly routed and reinstall the
driver's seat.
BATTERY SPECIFICATIONS (INTL)
Type
Varta Silver Dynamic
Voltage
12 V
Nominal Capacity
54 AH
@ 10 HR Rate
CCA
530
Nominal Open
12.8 V or more.
Circuit Voltage
Recommended
1.8 A @ 5-10 HR or 6.0 A @ 1
Charging Rate
HR
IMPORTANT
Never attempt to open the battery. If the seal is broken,
the battery will be ruined and will fail within a few
weeks.
BATTERY REMOVAL (INTL)
1. Remove the driver's seat to access the battery
2. Disconnect the black (negative) battery cable.
CAUTION
To reduce the chance of sparks: Whenever removing
the battery, disconnect the black (negative) cable first.
When reinstalling the battery, install the black (negative)
cable last.
3. Disconnect the red (positive) battery cable.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
CHASSIS / BODY ELECTRICAL
4. Remove the battery hold-down bracket
battery out of the vehicle.
BATTERY INSTALLATION (INTL)
Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can
also hinder vehicle performance. Refer to "Battery
Charging" page
q
.
1. Place the battery in the battery holder and secure
with hold-down strap. Torque fastener to
specification.
2. Coat the terminals with dielectric grease.
3. Connect and tighten the red (+)
4. Connect and tighten the black (-)
w
. Lift the
NOTICE
procedure before installing the
battery.
TORQUE
Battery Bracket:
3.5 lb-ft (5 Nm)
q
cable first.
w
cable last.
12
12.29