Gear Cluster Disassembly; Snorkel Shaft Removal / Disassembly - Polaris General 2020 Service Manual

GEAR CLUSTER DISASSEMBLY

q
1. Remove the bearing from the reverse shaft using a
bearing puller. Remove the retaining ring
e r
the washers , gear , and needle bearing
reverse shaft.
2. Remove the retaining ring
from the reverse shaft.
3. Remove the retaining ring
a s
bearing , and sprocket
4. Tilt the two shafts towards each other and remove the
silent chain from the two shafts.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
w
and slide
t
off the
y u
and engagement dog
i o
, washer , needle
from the reverse shaft.
5. If necessary, disassemble the other end of the
reverse shaft. Remove the bearing
f g
dog , retaining ring , washer
k
needle bearing from the reverse shaft.
SNORKEL SHAFT REMOVAL /
DISASSEMBLY
IMPORTANT
The pinion shaft must be removed prior to removing the
snorkel shaft assembly. Failure to remove pinion shaft
will result in damage to the snorkel shaft.
q
1. Extract the seal from the snorkel shaft to access
the snorkel tube for removal.
TRANSMISSION
d
, engagement
h j
, gear , and
7
7.25