Turn/Lights/Horn Switch (Int'l/Tractor); Horn; Turn Lights - Polaris General 2020 Service Manual

CHASSIS / BODY ELECTRICAL
TURN/LIGHTS/HORN SWITCH (INT'L/
TRACTOR)
Testing
1. Disconnect the Turn/Lights/Horn switch by
depressing the connector locks and pulling on the
connector. Do NOT pull on the wiring.
2. Test between the sets of outputs. If any of the tests
fail, replace the switch assembly.
• Turn on the High Beam. There should be continuity
between switch pins 2 and 5.
• Turn on the Low Beam. There should be continuity
between switch pins 2 and 6.
• Turn on the Left Turn Signal. There should be
continuity between switch pins 1 and 8.
• Turn on the Right Turn Signal. There should be
continuity between switch pins 1 and 7.
• Depress the Horn. There should be continuity between
switch pins 3 and 4.
12.72

HORN

q
The horn is located in the front of the unit behind the
radiator, accessible through the front left side of the
vehicle.

TURN LIGHTS

FRONT
The front turn lights are retained to the front bumper by a
q
single faster .
REAR
The rear turn lights are integrated into the rear taillight. If
the taillights are functioning properly but there is no
blinker, check the wiring connections and the flasher
module.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.