Polaris General 2020 Service Manual page 310

PVT SYSTEM
14. Install the Drive Clutch Holding Tool and torque the
retaining bolt to specification.
Drive Clutch Holding Tool:
9314177–A
TORQUE
Drive Clutch Retaining Bolt:
96 lb-ft (130 Nm)
15. Install the drive belt noting direction of belt rotation,
refer to "Drive Belt Installation" page 6.12
procedure. If a new belt is installed, install so
numbers can be easily read.
16. Install a new outer clutch cover seal with the colored
stripe facing the inner clutch cover.
17. Reinstall outer clutch cover and secure with screws.
Torque screws to specification.
TORQUE
Outer Clutch Cover Screws:
4.5 lb-ft (6 Nm)
18. Install inlet and outlet ducts and tighten hose clamps.
19. Install the left rear wheel. Refer to "Wheel
Installation" page
6.10
procedure.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.