PVT SYSTEM
DRIVEN CLUTCH SLIDER INSPECTION
The square sliders can be inspected with the driven
clutch installed on the vehicle.
Using a feeler gauge, measure the distance between the
q
slider and the stationary sheave at the widest point
. If
the measurement is over the service limit, the sliders or
driven clutch will need to be replaced. Also measure the
w
width of the slider block
. Replace the sliders if they are
smaller than the service limit.
6
MEASUREMENT
q
Slider to Sheave Clearance
:
Service Limit: 0.175" (4.5 mm)
w
Slider Width
:
Service Limit: 0.975" (24.8 mm)
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
6.29
© Copyright Polaris Inc.