Polaris General 2020 Service Manual page 328

PVT SYSTEM
4. If removed, install the rollers
u
clips onto the spider.
5. Install the spring so the arm
the moveable sheave.
o
6. Align the X's on the spider and moveable sheave.
6.28
t y
, washers and E-
i
rests into the notch in
7. Install the universal clutch compressor on the clutch
and compress the helix cover.
The helix cover is loaded by the spring. Not using a
proper compressor may result in personal injury or
damage to the clutch.
8. Align the marks previously made on the helix cover
and moveable sheave. Install the helix/cover and the
a
four fasteners . Torque fasteners to specification.
TORQUE
Helix Retaining Screws:
48 in-lbs (5 N·m)
9. Once back together, verify the grease / tape marks
made during disassembly are properly aligned.
10. Install the drive clutch on the vehicle. See PVT
Assembly page
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
CAUTION
© Copyright Polaris Inc.