Polaris General 2020 Service Manual page 166

ENGINE / COOLING SYSTEM
INSTALLATION
w
1. Install new seal into crankcase. Thread the drive
bolt of special tool PU-52493
IMPORTANT
The orientation of the seal is critical. Install the seal with
the flat side of the seal facing out as shown.
3.12
q
into the crankshaft.
2. Tighten the drive bolt
out against the crankcase.
3. Once the seal is properly installed, loosen the drive
e
bolt and remove special tool PU-52493 from the
crankshaft.
4. Refer to PVT Inner Cover Assembly page
5. Test drive the vehicle and recheck for leaks before
putting back into service.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
e r
until the cylinder bottoms
.
© Copyright Polaris Inc.