Polaris General 2020 Service Manual page 323

8. Tighten the spider jam nut using Clutch Spider Nut
d
Socket . Torque jam nut to specification.
Clutch Spider Nut Socket: PU-50578
TORQUE
Spider Jam Nut:
250 ft-lbs (339 N·m)(Apply 0.1 mL Loctite® 7088
Primer and 0.1 mL Loctite® 620™) in 90° apart to the
threads of the spider jam nut.
9. After the spider and jamb nut have been torqued,
remove the clutch assembly from the holding fixture
and inspect the alignment marks made during
disassembly.
NOTICE
If the marks illustrated below are not in alignment upon
assembly, the clutch will not be in balance and the drive
clutch assembly must be replaced.
f
10. Install the limiter spacer
IMPORTANT
DO NOT reassemble the drive clutch without the limiter
spacer. Belt life will be greatly reduced.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
g
and the clutch spring .
11. Install the drive clutch cover
in alignment.
j
12. Install cover bolts and torque in a cross pattern
evenly to specification.
TORQUE
Drive Clutch Cover Bolts:
9 ft-lbs (12 N·m)
PVT SYSTEM
h
. Be sure all marks are
6
6.23