Ignition / Key Switch - Polaris General 2020 Service Manual

IGNITION / KEY SWITCH

1. Disconnect the key switch harness by depressing the
connector lock and pulling on the connector. Do not
pull on the wiring.
2. Test between the 4 sets of outputs (OFF / ACCY / ON
/ START). If any of the tests fail, replace ignition
switch assembly.
• In the OFF position, there should be no continuity
between any of the pins.
• Turn the key to ACCY position. There should be
contunity between switch pins A and B.
• Turn the key to ON position. There should be
continuity between switch pins A, B and D.
• Turn the key to START position. There should be
continuity between all the pins on the switch.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
CHASSIS / BODY ELECTRICAL
AWD / 2WD / TURF SWITCH
PIN CONTINUITY
SWITCH POSITION
POS 1
ON
POS 2
OFF
POS 3
ON
SWITCH FUNCTION
PIN
1
2
3
4
5
6
7
8
CONTINUITY BETWEEN
Pins 2 and 3
—
Pins 1 and 2
FUNCTION
Turf Request Input
Ground, AWD Switch
AWD Request Input
—
—
—
Key Switch B+, AWD
Switch Light
—
12
12.67