Polaris General 2020 Service Manual page 564

BRAKE SYSTEM
REAR BRAKE LINE FROM JUNCTION
BLOCK TO CALIPERS ROUTING
1. If not previously done, install brake line onto junction
block.
NOTICE
The left rear brake line is positioned on the left side port
of the junction block rand the right rear brake line is
positioned on the rear port of the junction block.
TORQUE
Brake Line to Junction Block:
13 lb-ft (18 Nm)
2. Right Brake Line - From the junction block, route the
q
brake line along the chassis and secure in the
w
routing clips and routing clamps
fastener that secures the routing clamp to
specification.
NOTICE
The first routing clip secures both the right and left rear
break lines together.
TORQUE
Brake Line Retention Fastener:
8 lb-ft (11 Nm)
10.30
3. Route the brake line down the rear upper control arm
e
. Torque the
4. Install brake line onto rear caliper.
5. Left Brake Line - From the junction block, route the
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
and secure with the routing clamps
r
clamp .
TORQUE
Rear Caliper Fasteners:
46 lb-ft (62 Nm)
q
brake line along the chassis and secure in the
w
routing clip and routing clamp
NOTICE
The routing clip secures both the right and left rear
break lines together.
e
and wire/tube
e
.
© Copyright Polaris Inc.