BATTERY INSTALLATION
NOTICE
Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can
also hinder vehicle performance. Refer to "Battery
Charging" page
procedure before installing the
battery.
1. Place the battery in the battery holder and secure
with hold-down strap. Torque fastener to
specification.
TORQUE
Battery Bracket:
3.5 lb-ft (5 Nm)
2. Coat the terminals with dielectric grease.
3. Connect and tighten the red (+)
4. Connect and tighten the black (-)
5. Verify that cables are properly routed and reinstall the
driver's seat.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
BATTERY REMOVAL (INTL)
1. Remove the driver's seat to access the battery
2. Disconnect the black (negative) battery cable.
q
cable first.
w
cable last.
To reduce the chance of sparks: Whenever removing
the battery, disconnect the black (negative) cable first.
When reinstalling the battery, install the black (negative)
3. Disconnect the red (positive) battery cable.
4. Remove the battery hold-down bracket
battery out of the vehicle.
MAINTENANCE
q
.
CAUTION
cable last.
w
. Lift the
2.55
2