Polaris General 2020 Service Manual page 476

STEERING / SUSPENSION
LOWER CONTROL ARM
1. Insert NEW pivot caps
e
and pivot tube into new control arm. A light press
force may be needed.
2. Install lower control arm assembly onto vehicle frame.
Torque NEW fasteners
NOTICE
2019 models have M12 hardware.
2016–2018 models have M10 hardware.
TORQUE
Front Control Arm Fasteners:
42 lb-ft (57 Nm)
9.32
q
, control arm bushings
r
to specification.
3. Insert lower control arm ball joint end into the bearing
carrier. Install lower ball joint pinch bolt into the
w
,
bearing carrier and torque bolt to specification.
4. Install front wheels. Refer to "Wheel Installation"
page procedure.
Upon control arm installation, test vehicle at low speeds
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
TORQUE
Ball Joint Pinch Bolts:
42 lb-ft (57 Nm)
WARNING
before putting into service.
© Copyright Polaris Inc.