Polaris General 2020 Service Manual page 575

REAR BRAKE LINE FROM JUNCTION
BLOCK TO CALIPERS ROUTING
1. If not previously done, install brake line onto junction
block.
NOTICE
The left rear brake line is positioned on the left side port
of the junction block rand the right rear brake line is
positioned on the rear port of the junction block.
TORQUE
Brake Line to Junction Block:
13 lb-ft (18 Nm)
2. Right Brake Line - From the junction block, route the
q
brake line along the chassis and secure in the
w
routing clips and routing clamps
fastener that secures the routing clamp to
specification.
NOTICE
The first routing clip secures both the right and left rear
break lines together.
TORQUE
Brake Line Retention Fastener:
8 lb-ft (11 Nm)
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
3. Route the brake line down the rear upper control arm
and secure with the routing clamps
clamp
e
. Torque the
4. Install brake line onto rear caliper.
5. Left Brake Line - From the junction block, route the
brake line
routing clip
The routing clip secures both the right and left rear
BRAKE SYSTEM
e
r
.
TORQUE
Rear Caliper Fasteners:
46 lb-ft (62 Nm)
q
along the chassis and secure in the
w e
and routing clamp .
NOTICE
break lines together.
and wire/tube
10
10.41